Thingiverse
Electronics
Zum Modell
0.96inch oled case
39
Downloads
49
Likes
0
Makes
The original case was a bit small for my use, so I scaled the case to 110%.
I made a frame to hide the gap between the OLED and the case.
(I removed the pin inside the case because it gets in the way of the frame. I fixed the frame with double-sided tape.)
Shows the number of days remaining until the university entrance examination in Japan.
In addition to OLED, I use Seeeduino XIAO and Grove High Precision RTC.
I made a frame to hide the gap between the OLED and the case.
(I removed the pin inside the case because it gets in the way of the frame. I fixed the frame with double-sided tape.)
Shows the number of days remaining until the university entrance examination in Japan.
In addition to OLED, I use Seeeduino XIAO and Grove High Precision RTC.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
