Thingiverse
1/2" Clamping Knob
von OSUaeronerd
3
Downloads
6
Likes
0
Makes
A simple clamping knob for my 1/2 shaft magloop variable capacitor.
Use a 1" 10-24 bolt and nylock nut to tighten the clamping knob onto the 1/2 shaft. This of course could be used with any 1/2 shaft, and smaller if you want to remix this, or create a collar to fit your design. I suppose scaling would also work, but might make using a bolt more difficult.
Just putting this up for others to use.
Use a 1" 10-24 bolt and nylock nut to tighten the clamping knob onto the 1/2 shaft. This of course could be used with any 1/2 shaft, and smaller if you want to remix this, or create a collar to fit your design. I suppose scaling would also work, but might make using a bolt more difficult.
Just putting this up for others to use.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
