Thingiverse
1/2" PVC Pixel Clip
von jlange
83
Downloads
35
Likes
0
Makes
This is a slight modification of the 1/2" PVC clip found at https://www.thingiverse.com/thing:4088932.
This clip features a channel at the bottom to allow RGB pixel wires to run though the clip while still allowing the pipe to sit flush. The base stand-off was also extended to provide 1/2" of height.
This clip features a channel at the bottom to allow RGB pixel wires to run though the clip while still allowing the pipe to sit flush. The base stand-off was also extended to provide 1/2" of height.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
