1/24 Stackable Display shelf Diecast

I recently took time to print about 8 display cases from here as I was new I didn't realize how bad they were made for using with diecast displays so I worked on this version of my own display shelf that is stackable. These do have low clearance but should work with most 1/24 scale diecast models as well as smaller ones (IE like 1/43 or 1/64 spread out) There are 2 STLs, pretty straight forward, one is meant to the bottom and the other is the top. I'd recommend stacking 2 to 3 shelfs depending on weight and your setup. This wasn't designed to be a “quick print” shelf, this is designed to be strong and to last. I made this with a few honeycomb shapes to save a little bit of filament without losing and the strength, but that's also why I have added supports going up the side and 1 support “bar” in the middle which if printed in say PLA (like mine) it would help keep the strength. I recommend: Wall loops: 3 Top shell layers: 4 Top shell thickness: 1.2 Sparse infill density: 12% Infill Pat