1/4-20 mount adapter for Stream Deck + Plus

Adapter to mount the Stream Deck + to any ¼&#34;-20 thread (typically used by camera equipment). Attaches using the screws for the base that comes with the Stream Deck +, does not require any glue and will not void your warranty. Works well in PLA and ABS. Printed on a P1S with 0.2 mm layer height and 25% infill, no supports needed. Uses <20 g of filament. Note that this is intended for use with cheap, rectangular ¼&#34;-20 t nuts such as these from Taytools. Simply place the t-nut in the hole, screw it to the ¼&#34;-20 mount, then screw it to the Stream Deck +. No glue is required as the t-nut will be pulled tight by the mount, but you can also glue it in place if you prefer. If you have a different adapter or just wish to do something else with the model, I have also included a Fusion 360 file that you are free to modify however you please. Also note that this is technically a remix of a sim rig mount I found on Elgato Marketplace. There&#39;s very little left in common with it, but