Thingiverse
1/4" Propane Quick Connect Cap
1
Downloads
0
Likes
0
Makes
Ah, the end of camping season in Canada—a time to reflect on all the little tasks I should have done but didn't. One that kept haunting my backcountry dreams was creating a cap for my BBQ quick connect fitting.
Despite the fitting being 1/4", the land of the metric system demands a 14 mm base size. Makes you appreciate the simplicity of the metric system! This clever cap embraces a friction fit, perfectly sliding over the 14 mm base and staying put like an old friend.
I've gone with PLA+ for my printing needs, still awaiting a truce with ABS and ASA filament. Perhaps one day, I'll forge peace with those temperamental filaments.
Thoughtfully added is a tie-off point, allowing you to secure the cap to the propane hose—no more playing hide and seek after you're done grilling.
Happy camping! May your cap always remain where it belongs!
Despite the fitting being 1/4", the land of the metric system demands a 14 mm base size. Makes you appreciate the simplicity of the metric system! This clever cap embraces a friction fit, perfectly sliding over the 14 mm base and staying put like an old friend.
I've gone with PLA+ for my printing needs, still awaiting a truce with ABS and ASA filament. Perhaps one day, I'll forge peace with those temperamental filaments.
Thoughtfully added is a tie-off point, allowing you to secure the cap to the propane hose—no more playing hide and seek after you're done grilling.
Happy camping! May your cap always remain where it belongs!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
