Thingiverse
1/48 Savannah Master
door Lord_Squeek
5
Downloads
4
Likes
1
Makes
A Savannah Master scaled up to about 1/48 scale. Can't say it is 100% accurate as there are currently no hard numbers to draw upon, but it is close by my standards. An appropriately sized base with alignment nub, to tell facings, has been included.
Use 1.75mm filament as alignment pegs and everything should line up without too much trouble, but be aware that if you rescale it, then you will need to redo the holes or find another material to go into the alignment holes.
No supports needed. Will print on FDM printer with 0.4 nozzle (recommended layer height is 0.08) but I do recommend a simple brim to help hold on to the printer bed. Do recommend cleaning up the brim on any area you think you can't get to after it is glued together, then glueing it and then removing the remaining brim material. This will help fill in the seam between the two parts nicely. As always file/sand away at any problem areas and have fun. Recommend doing any basing on the base first then glue the model to
Use 1.75mm filament as alignment pegs and everything should line up without too much trouble, but be aware that if you rescale it, then you will need to redo the holes or find another material to go into the alignment holes.
No supports needed. Will print on FDM printer with 0.4 nozzle (recommended layer height is 0.08) but I do recommend a simple brim to help hold on to the printer bed. Do recommend cleaning up the brim on any area you think you can't get to after it is glued together, then glueing it and then removing the remaining brim material. This will help fill in the seam between the two parts nicely. As always file/sand away at any problem areas and have fun. Recommend doing any basing on the base first then glue the model to
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!