Thingiverse
1" Flagpole Side Mount
door djsmith89
6
Downloads
3
Likes
1
Makes
https://www.thingiverse.com/thing:3729088 was meant for a 3/4" flag pole, but mine was 1". I resized the bore to 26mm for a bit of wiggle room, but mine came out just snug enough to not need the M5 screw. Added a drainage hole.
Recommended orientation is with the drainage hole side down. I printed with a raft, but that's because my glass bed can have poor adhesion. YMMV.
Recommended orientation is with the drainage hole side down. I printed with a raft, but that's because my glass bed can have poor adhesion. YMMV.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!