Thingiverse
1 inch pvc wall bracket
par tattooedfish
58
Téléchargements
62
Likes
0
Makes
I orginally needed a wall mount bracket for pvc rack I built to hold my airplanes. I found this one. II had an issue after a few days the pvc pipe kept popping out due to the pla flexing slightly and could not hold very much weight.
I also trimmed the design down slightly to improve print time and use less material
I came up with this remix that fully encloses around the pipe. I was able to print this with no issue and slid right onto my 1 inch pvc but still fit snug.
I recommend printing on one of the sides strength.
I also trimmed the design down slightly to improve print time and use less material
I came up with this remix that fully encloses around the pipe. I was able to print this with no issue and slid right onto my 1 inch pvc but still fit snug.
I recommend printing on one of the sides strength.
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !
