10 cent bottle opener

After seeing some of the other bottle openers out there I designed my own in Fusion 360 to use an Australian 10 cent coin.

The coin needs to be inserted during printing and is not removable afterwards. Pause printing at the 4mm layer height to insert the coin.

I've printed it in PLA at 200 C on Flashprints Low (fast) profile with 100% infill, prints in approx 40 mins on a flashforge finder.

I will print again at a higher resolution for a better surface finish after it has been stress tested for a few weeks.

Was designed on 22/01/2020

If you like them, please print and share them with your friends, modify them with logos or names etc, and don't forget to enjoy your favourite beverage.