Thingiverse
10" Oscar Statue
von MarcusPfeiffer
220
Downloads
200
Likes
0
Makes
I can't remember whose scan of an Oscar Statue was my original source. It was crap anyway. Impossible to print because of a thousand flaws.
I fixed all of the flaws and scaled it to 10" overall height and split it into front and back halves.
This produces a much nicer finish and prevents those common failures on tall printouts.
It has 5 5mm alignment holes where You can put cut-off screws before gluing the halves together. The holes have triangular tops so no overhang printing gunk will get in there.
I've added a conical void in the base, which can be filled with metal junk mixed with glue for weight. I've got old bins of nuts and bolts which I could use.
Being conical, nothing requires supports.
I use a single line of Skirt to prime the nozzle. No rafts or brim is required because of full build plate contact.
Glue it with crazy glue.
I fixed all of the flaws and scaled it to 10" overall height and split it into front and back halves.
This produces a much nicer finish and prevents those common failures on tall printouts.
It has 5 5mm alignment holes where You can put cut-off screws before gluing the halves together. The holes have triangular tops so no overhang printing gunk will get in there.
I've added a conical void in the base, which can be filled with metal junk mixed with glue for weight. I've got old bins of nuts and bolts which I could use.
Being conical, nothing requires supports.
I use a single line of Skirt to prime the nozzle. No rafts or brim is required because of full build plate contact.
Glue it with crazy glue.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
