Thingiverse

100hex mosaic assembly

by I_am_me

2k Downloads

1.6k Likes

8 Makes

Go to Model

This is designed in order to facilitate the creation and hanging of mosaics.
It was specifically designed to fit the tiles from the 100hex project https://www.thingiverse.com/thing:2477471

The Holder.stl file has a cutout in the back which is used to fit a nail and hang it on the wall.
All the other panels connect together, as such a whole mosaic can be hanged easily, without glue or tape and with minimal damage to the wall (just 2 nails).

There is a 0.2mm gap between the tile and the panel, it should be a friction fit.
However, if your printer is extremely well tuned you might find you need to scale the tile by a tiny amount to ensure it stays secure.
The gap between the grooves and the tabs is 0.4mm as I found 0.2mm was too tight for assembly.

IMPORTANT : There are 2 type of panels, the ones starting with Edge\_\* have the edge at the top, the ones starting with Corner\_\* have the corner at the top (check the pictures for a better understanding)

Leave a comment if y

100hex art assembly decor Decoration diy furniture hex hexagon wall wall mount wall plate 100hex art assembly decor Decoration diy furniture hex hexagon wall wall mount wall plate 100hex art assembly decor Decoration diy furniture hex hexagon wall wall mount wall plate

Source

Thingiverse

What you need to print this: Intermediate Low confidence

Single piece

Supports 1/3

Assembly 0/3

Settings 1/3

Bed size 0/3

Post-process 1/3

Printer

FDM / FFF

File format