104001 Top Brace

Hi everyone !

Here are a few parts to get rid of the WLtoys 104001 chassis flex.
It consists of 2 top plates, and 2 little standoffs.
I simply used 8 M3 x 10mm to mount it. You could use some of your stock screws, especially if you reduce the thickness of the plates down to 3mm.

Material to avoid : PLA
Material to use : PETG / PLA + / PETG CF / Nylon / Nylon CF etc.
Infill recommended : At least 20%, but I recommend 50% and more.
Infill patern recommended : Gyroid for maximum stress resistance
Supports : NO

I personally use the "Original 5mm" design. But I made a thinner design and also a design that should allow you to mount bigger motors.


I hope you enjoy ! Any donation of a symbolic euro will be very appreciated !

https://www.youtube.com/watch?v=46iI_jvOQFc

Have fun :)

Mehdi