Back
3DSEARCH / Electronics Board Side-Mount
Electronics Board Side-Mount – 3D printable model from Thingiverse Thingiverse

Electronics Board Side-Mount

by Nix-7c0
0 Downloads
3 Likes
0 Makes
Download Model
electronics mount part reprap side snap on
This is a snap-on mount for Mendel electronics which you can use to mount your boards on the side, rather than on the face where it interferes with accessing the carriage.
Source
Thingiverse
Comments
0

Bewertung

Noch keine Bewertungen

Comments

No comments yet – be the first!
All Thingiverse Models More by Nix-7c0

Similar Models

6 Suggestions
Quadcopter electronics stack mount (flight controller, power module, receiver)
Quadcopter electronics stack mount (flight controller, power module, receiver)
by zargony
↓ 75 ♥ 47
AM8 Orange Pi Lite mount
AM8 Orange Pi Lite mount
by AUREL_14
↓ 3 ♥ 2
Electronics Mount Ramps + 2x Mosfet + Thermocouple
Electronics Mount Ramps + 2x Mosfet + Thermocouple
by Ludicer
↓ 7 ♥ 8
YB4835VA Holder for MPCNC Modular Electronics
YB4835VA Holder for MPCNC Modular Electronics
by jmg123
↓ 3 ♥ 5
Kossel mini Arduino/Ramp1.4 mount
Kossel mini Arduino/Ramp1.4 mount
by elmuchacho
↓ 20 ♥ 11
Portal radio
Portal radio
by Aibot
♥ 723

Add to Collection