Thingiverse
12.5mm Bed Mount for HyperCube Evolution
von michaeldeberry
8
Downloads
4
Likes
1
Makes
The mount holes were a little bit different for the bed that I bought so the 15mm mounts didn't work.
I found other 12.5mm mounts, but they had the hole for the leveling screw in the center so the thumb screw couldn't fit because the mount screw was in the way.
With this version the hole for the bed leveling screw is offset.
I found other 12.5mm mounts, but they had the hole for the leveling screw in the center so the thumb screw couldn't fit because the mount screw was in the way.
With this version the hole for the bed leveling screw is offset.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
