Thingiverse
12" subwoofer grill Edge sub
door Dozsmith
2
Downloads
3
Likes
0
Makes
I wanted a bit of protection for the Halfords Edge sub in the boot of my car so came up with these.
Printed in PETG with 0.6, 25% infill, will need supports.
Update -
After fitting these I ended up using them to pull the sub around, and with just 2 screws per ring they felt a bit weak so I created the ring to bind them together.
The template can be used to mark and drill some holes for m3 screws that can be used to screw in to m3 4.2x4mm heat set inserts. The purpose of this was to make it removable. However after fitting this it works far better with a bit of super glue and so the screws can be used to clamp until set up. or just dont bother with the screws if you have clamps or tape or what ever.
With the ring on this is now really solid and I use as a handle when moving it around now.
Printed in PETG with 0.6, 25% infill, will need supports.
Update -
After fitting these I ended up using them to pull the sub around, and with just 2 screws per ring they felt a bit weak so I created the ring to bind them together.
The template can be used to mark and drill some holes for m3 screws that can be used to screw in to m3 4.2x4mm heat set inserts. The purpose of this was to make it removable. However after fitting this it works far better with a bit of super glue and so the screws can be used to clamp until set up. or just dont bother with the screws if you have clamps or tape or what ever.
With the ring on this is now really solid and I use as a handle when moving it around now.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!