Thingiverse
120mm fan rack
por uzosan
3
Descargas
3
Likes
0
Makes
A standard 120mm PC fan can be installed in this fan rack. Fitting fan mounting holes are also available.
I designed the rack to circulate the accumulated heat behind my fireplace. But I'm sure there are other use cases too.
Support should not be needed to print. My Ender was able to bridge the gap.
The joints between the parts are very tight. Depending on the precision of your printer, you may need to sand them a little.
I designed the rack to circulate the accumulated heat behind my fireplace. But I'm sure there are other use cases too.
Support should not be needed to print. My Ender was able to bridge the gap.
The joints between the parts are very tight. Depending on the precision of your printer, you may need to sand them a little.
uzosan también publica en
20 modelos adicionales en 1 plataformas más
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
