Thingiverse
Front and Back for ZMR250
1
Downloads
17
Likes
0
Makes
Made little front and back parts for the ZMR250 Frame.
You can put threaded inserts in the holes and screw directly into them or you can widen the holes a bit so they fit over the standoffs.
EDIT: Added one with standoffs for the Camera to Screw in, now the Lens should also be better protected
Drilled the mounting holes for the camera afterwards because of different measurements.
On the backside you can fit through the SMA connector from your VTX and battery connector on top (hot glued i
You can put threaded inserts in the holes and screw directly into them or you can widen the holes a bit so they fit over the standoffs.
EDIT: Added one with standoffs for the Camera to Screw in, now the Lens should also be better protected
Drilled the mounting holes for the camera afterwards because of different measurements.
On the backside you can fit through the SMA connector from your VTX and battery connector on top (hot glued i
Sign in to leave a comment
Sign in