128x32 OLED Display Bezel

This is a simple, clip-on bezel for the Frienda brand 0.91" OLED display modules available on Amazon. It may work for similarly shaped modules made by other manufacturers, but no guarantees, it's designed to be a tight fit so it doesn't slop around. Your printer should have good tolerances too. There's no attachment points for the bezel itself, so the header pins are your primary means for holding the display in place. This design was basically intended to protect the display (and make the setup look a little nicer) while doing breadboard prototyping. There's nothing to stop you from using it in a finished project though.