Thingiverse
12v Dust Plug
von jdharris
8
Downloads
10
Likes
0
Makes
After upgrading my Anycubic Linear Plus to a heated bed and a new power supply, I had the old 12v port on the Trigorilla board left open. Just to ensure that it is protected, I created a dust plug to go into the open port. I made this from MakerGeeks Maker Flex flexible filament.
The power_plug.stl file is made to fix the board holder/trim piece that has an outer opening of 9mm. The power_plug_original.stl is made to fix the stock acrylic trim piece with the elongated hole.
The power_plug.stl file is made to fix the board holder/trim piece that has an outer opening of 9mm. The power_plug_original.stl is made to fix the stock acrylic trim piece with the elongated hole.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
