12V voltage regulator case (parametric)

A simple case to hold a 12V voltage regulator such as the one sold on AliExpress [here](https://www.aliexpress.us/item/3256806900119291.html). The model defaults are for that specific regulator but the parameters can be modified to accommodate others.

#### Usage
1. Check to make sure the regulator works the way you expect it to (i.e. you're not undervolting based on supply)
2. Print both the box and lid
3. Strip the wires as needed and run them through the provided holes on either side of the base
4. Screw the wires into the voltage regulator as required
5. Slip the regulator into place, aligning the standoffs and knob
6. Check the fit of the lid
7. Using your method of choice (heated filament, soldering iron, glue, etc.) fuse the lid and the base together
8. Screw the knob hex nut into place
9. Slide the knob dial onto the knob

#### Recommended Print Settings
* 0.4mm nozzle
* 0.2mm layer height
* 10% infill
* No supports
* Print as oriented

#### Parameters
![](https://media.printab