Thingiverse
13mm Servo Holder
por 1Smug_Bastard
1
Descargas
1
Likes
0
Makes
Servo Holder for use with BMS-385DMAX. (13 mm wide) If printed from Nylon, it should weight about 2 Grams.
Main hole is for 9.5 x 9.5 mm Carbon rod with zip-ties used to secure the entire assembly.
Granted, David's shops says these rods are 10 x 10 mm but my measurements show differently. Guessing there is some variance in the rod dimensions so some filling out of the hole may be necessary to achieve the correct fit.
16-Nov-2018: Added updated file for better fit.
Main hole is for 9.5 x 9.5 mm Carbon rod with zip-ties used to secure the entire assembly.
Granted, David's shops says these rods are 10 x 10 mm but my measurements show differently. Guessing there is some variance in the rod dimensions so some filling out of the hole may be necessary to achieve the correct fit.
16-Nov-2018: Added updated file for better fit.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
