Thingiverse
Guardian Lions Clock
by Skyblue
70
Downloads
67
Likes
0
Makes
80mm opening should fit any single battery clockworks.
Glue dial to disk, glue clockworks to back of disk, glue assembly to clock body
Support is required on this print..
Finished model was painted with gold spray paint.
Printed in ABS @.3mm, 2 perimeters, two tops, two bottoms, 20 percent infill.
Note: Disk has been modified to fit better, thanks to ElmoC.
Note: Ran out of filament at the end of print, only a few layers left, so I stopped the print, and that accounts for the open face o
Glue dial to disk, glue clockworks to back of disk, glue assembly to clock body
Support is required on this print..
Finished model was painted with gold spray paint.
Printed in ABS @.3mm, 2 perimeters, two tops, two bottoms, 20 percent infill.
Note: Disk has been modified to fit better, thanks to ElmoC.
Note: Ran out of filament at the end of print, only a few layers left, so I stopped the print, and that accounts for the open face o
Sign in to leave a comment
Sign in