RotorX Atom Camera Mount V3 _ 170deg CC1356

This is my revision of the camera mount I use. I was sick of the hot glue coming loose and letting my camera get vibrations. Added the strap which is secured using two M2x6mm screws.

Note 1: This is a couple of mm higher than a standard Atom V1 stack, so if you need it shorter than it is, simply tell your slicer to stop printing at your desired height.

Note 2 : The strap works with the 25 degree mount, but i havent tested it with the other two, but it should work. If its too loose just pu