Thingiverse
Printrbot Plus V1 offset Z-axis nut: less wobble
by tdeagan
8
Downloads
6
Likes
1
Makes
Remix of Tom_Maragos's http://www.thingiverse.com/thing:104733 to fit my V1 Printrbot Plus.
The OpenSCAD file takes the original STL, closes the hex nut and threaded rod hole, creates new centered rod and hex holes (joined with a conical section to avoid bridges during printing.
This is set up for a M8x1.25 metric rod and nut, but the OpenSCAD file could be easily changed for any size.
The original file has differing left and right units. I used the same unit for both sides, but had to
The OpenSCAD file takes the original STL, closes the hex nut and threaded rod hole, creates new centered rod and hex holes (joined with a conical section to avoid bridges during printing.
This is set up for a M8x1.25 metric rod and nut, but the OpenSCAD file could be easily changed for any size.
The original file has differing left and right units. I used the same unit for both sides, but had to
Sign in to leave a comment
Sign in