Thingiverse
15cm LED Strip Light
von kote315
2
Downloads
0
Likes
0
Makes
15cm LED Strip Light
The two halves are connected by latches. If it's not strong enough, add some glue around the edges. Print with transparent plastic [obviously].
No supports.
Layer thickness 0.16 mm or less.
The two halves are connected by latches. If it's not strong enough, add some glue around the edges. Print with transparent plastic [obviously].
No supports.
Layer thickness 0.16 mm or less.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
