15x7 CharliePlex Enclosure with Translucent Window

A small rugged weather-proof enclosure for the 15x7 CharliePlex FeatherWing and Adafruit HUZZAH32 – ESP32 Feather Board.The window can be printed in the lid in translucent filament (PLA or PETG) but should be the same material type as the enclosure.A small 1100mAh battery also fits under the mounting plateThe CharliePlex in mounted to the lid with small M2.5 x 5mm screws.The mounting plate is secured with M3 x 6mm screws. I filled the groove in the body of the enclosure with JB weld liquid gasket to create a gasket, wait 24 hours to set! The ridge on the lid will compress the gasket and create a water-tight seal!It's recommended to print in at least PETG filament for outdoor use! 4 of the clasp are needed per box, and they are attached to the lid with 20mm M3 bolts and nuts.4x 20mm bolts are also used as clasp-points on the body.