Motor mount for the Dayton 1LNH1 Dc Motor

Had to make a bracket to mount the motor, that I replaced ( http://www.ebay.com/itm/321131266241?_trksid=p2060353.m1438.l2649&ssPageName=STRK%3AMEBIDX%3AIT ) as no one had one for it. The previous motor was just not strong enough to move the extruder, once the pellets were added in. The new motor I hope should do better, if not I'll be going to the junk yard for a wiper motor. Then I'll be back at the drawing board designing another new bracket.

The new motor that goes along with this bracket