Thingiverse
LS-210/qav 210 mobius & runcam mount
by Telnoi
16
Downloads
8
Likes
0
Makes
PLA should be printed with hard plastic.
TPU should be printed with a rubbery type filament.
The hard plastic part will prevent the top plate screws from being pulled through the cam mount. Printing in TPU will prevent the mount from breaking. You are more likely to destroy your entire quadcopter before the mount will break.
Please note, there are different versions of the LS-210 or lisam 210 frame out there. The older version is bigger compared to the QAV 210. This print is ONLY suitable
TPU should be printed with a rubbery type filament.
The hard plastic part will prevent the top plate screws from being pulled through the cam mount. Printing in TPU will prevent the mount from breaking. You are more likely to destroy your entire quadcopter before the mount will break.
Please note, there are different versions of the LS-210 or lisam 210 frame out there. The older version is bigger compared to the QAV 210. This print is ONLY suitable
Sign in to leave a comment
Sign in