Back
Mosquito Terminator – 3D printable model from Thingiverse Thingiverse

Mosquito Terminator

19 Downloads
16 Likes
0 Makes
Download Model
After getting annoyed over the low success rate I had while trying to kill mosquitoes in my room using the traditional bashing method, I decided to print this part. The success rate with it is almost 100%.
Cons: It can only be used on flat surfaces (corners are an issue) and only if the mosquito is in reach.

Hunting method: Slowly approach the mosquito with the beaker and trap it. Push the stamp completely down. Wipe the stamp and the wall clean with a tissue
Source
Thingiverse
Comments
0

Bewertung

Noch keine Bewertungen

Comments

No comments yet – be the first!
All Thingiverse Models More by Serachja

Add to Collection