Thingiverse
17HMR Snap Cap
por ShaneGoodwin501
1
Descargas
1
Likes
0
Makes
This is my take on the 17HMR home made Snap Cap. I have created a divit in the bottom so that you can place some rubber in there to absorb the hammers impact safely.
I print this using pla+ and with 100% infill at 25mm/sec. Its small so go slow. :-)
I print this using pla+ and with 100% infill at 25mm/sec. Its small so go slow. :-)
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
