Thingiverse
18" Doll Walking Boot/Cast
von JFire007
4
Downloads
1
Likes
1
Makes
This is a walking boot/cast for an 18" doll. There are star shaped holes to reduce PLA, mimic branding, and promote air flow (if it were real).
I used 3mm magnets from TEMU to attract both halves together.
Print open side up with supports.
I used 3mm magnets from TEMU to attract both halves together.
Print open side up with supports.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
