Thingiverse
180 class quadcopter frame
von Parkush
59
Downloads
40
Likes
1
Makes
My design for a 180 tweaker quadcopter frame.
The design is meant to be easy to print.
I'm working on holes for XT60 plug and pigtail for the vtx. They will be in the top plate.
The camera hole, the zip tie holes, and the end stop, is made for the small Fat Shark FPV.
The square hole in the side is meant for the USB connection of a Naze32
NOTES:
Right now there are no holes to bolt the top plate to the frame. I'm not too bothered as I am sure my PLA version will shatter at first high speed impact anyway, so I will just use glue.
Thinking of adding 2204 size motor guards on the front arms.
The design is meant to be easy to print.
I'm working on holes for XT60 plug and pigtail for the vtx. They will be in the top plate.
The camera hole, the zip tie holes, and the end stop, is made for the small Fat Shark FPV.
The square hole in the side is meant for the USB connection of a Naze32
NOTES:
Right now there are no holes to bolt the top plate to the frame. I'm not too bothered as I am sure my PLA version will shatter at first high speed impact anyway, so I will just use glue.
Thinking of adding 2204 size motor guards on the front arms.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
