Thingiverse
180mm diameter drain cover
von Andy1205
3
Downloads
1
Likes
0
Makes
My outdoor drain cover broke and so I designed this based on the original pattern.
It does not need supports if printed so the bottom edge is flat against the bed.
Use PETG for strength and protect against the elements. You can incrase the fill % for added strength is required, but mine is OK at 20% infill, although not driven over by cars very often.
It does not need supports if printed so the bottom edge is flat against the bed.
Use PETG for strength and protect against the elements. You can incrase the fill % for added strength is required, but mine is OK at 20% infill, although not driven over by cars very often.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
