18350 Dna 30 micro mod

New case for you all. I've tested it and it works great.

Please keep in mind that running a dna 30 at the full 30 watts will overdraw the amp capacity of any 18350 battery. Keep wattage below 20 watts to ensure safe use.

Uses standard keystone battery contacts, and a fat daddy v4 short or v5 510 connection. Assembly should require no glue except to secure 6mm neo magnets(x4). Be forewarned, because of the 4 part construction and small size it's going to be very tough to assemble.

A few assembly tips:
wire everything before hand, make the negative lead just long enough with no slack and the positive lead with a bit of excess slack to give you the needed room to shimmy the battery tray in after placing the DNA tray and buttons inside. Tread the pre wired positive pin into the 510 before you insert it into the case then screw the 510 into the case and locking knot/negative contact at the same time to avoid any wire twisting. Battery Door may need minor sanding to get a nice ti