Lack Table Leveling Foot

This is a leveling foot designed to be used with a Lack table from Ikea. It requires 4x printed feet, 4x 5/16" T-nuts, and 4x 5/16" x 1 1/2" hex bolts.

Find the center of the bottom of each Lack Table leg and drill a 3/8" hole at least 1 1/2" deep. Place the T-nut in the hole and secure it in place with a hammer.

Place the leveling foot on the head of each bolt. If the fit is too tight, you can try reprinting at a slightly larger scale.

Screw the bolt and leveling foot into each leg of