Thingiverse
Electronics
Go to Model
18650 3s7p pack
96
Downloads
96
Likes
0
Makes
18650 3s7p pack i made for my robot lawnmower.
You will need to print 2 of each stl's for the full pack
Uses M3 screws. I used 35mm screws but shorter ones might work ok
Spot weld your nickel strips first then screw on lids and supports. The BMS I'm using fits on the side of pack no problem.
You will need to print 2 of each stl's for the full pack
Uses M3 screws. I used 35mm screws but shorter ones might work ok
Spot weld your nickel strips first then screw on lids and supports. The BMS I'm using fits on the side of pack no problem.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
