Thingiverse
18650 80P Battery Pack
von chiphead420
22
Downloads
15
Likes
0
Makes
This is a battery pack design I plan to use for my DIY PowerWall. It holds 80 18650 batteries and features channels for the buss bars and fuses and break-a-way tabs in the event of needing to replace a cell.
Need to print 4 pieces of the tray and 5 pieces of the connector for each pack. Note the tray has one end that has a flat edge. These to ends mate with a connector spanning them both.
A Spot of hot glue on the connectors in the corners will hold them well in place.
This is a work in progress as I have not received the fuses I will be using, nor have I decided on the final buss bar. Subscribe to get updates.
Need to print 4 pieces of the tray and 5 pieces of the connector for each pack. Note the tray has one end that has a flat edge. These to ends mate with a connector spanning them both.
A Spot of hot glue on the connectors in the corners will hold them well in place.
This is a work in progress as I have not received the fuses I will be using, nor have I decided on the final buss bar. Subscribe to get updates.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!