Thingiverse
18650 battery holder with spring
von spiritplumber
16
Downloads
7
Likes
0
Makes
A simple 18650 battery holder.
If printed with ABS, it will also negate the need for springs - just wrap copper wire around the pre-printed springs and let it come out of the premade hole.
Depending on your current needs, you can also use a bit of aluminum foil, wrap the spring pieces in it and connect a wire.
This negates the need to buy springs that fit the design, which is handy if you need a battery holder at three in the morning.
Be sure to check out my other work at https://www.robots-everywhere.com/
If printed with ABS, it will also negate the need for springs - just wrap copper wire around the pre-printed springs and let it come out of the premade hole.
Depending on your current needs, you can also use a bit of aluminum foil, wrap the spring pieces in it and connect a wire.
This negates the need to buy springs that fit the design, which is handy if you need a battery holder at three in the morning.
Be sure to check out my other work at https://www.robots-everywhere.com/
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
