Thingiverse
18650 PCB Case Mod'd UPS Battery
di CPS_Systems
6
Download
7
Likes
0
Makes
Remix of "Wemos 18650 charge circuit shield case" incorporating adjustments.
First, my slicer/printer refused to deal properly with the screw holes on the bottom so those are changed to use flat head screws.
My PCB's USB A ports were attached out of alignment so the print opening is widened side to side.
To be able to "see" the LEDs on the board there's now a thin section in the bottom piece.
Added some “posts” to the tops of both pieces to help with alignment and strength.
And finally, to indicate which position the switch is, there's a "0 for off" and a "1 for on".
First, my slicer/printer refused to deal properly with the screw holes on the bottom so those are changed to use flat head screws.
My PCB's USB A ports were attached out of alignment so the print opening is widened side to side.
To be able to "see" the LEDs on the board there's now a thin section in the bottom piece.
Added some “posts” to the tops of both pieces to help with alignment and strength.
And finally, to indicate which position the switch is, there's a "0 for off" and a "1 for on".
CPS_Systems pubblica anche su
349 modelli aggiuntivi su altre 2 piattaforme
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
