18mm Vortex Rocket remix Estes C

Just adding some slight mods to HAL 9000's design. But it's about 85% the same as his.
Key differences
1. I added a motor retainer already built in.
2. I added a baffle inside the fin section. Hopefully won't need parachute wadding
3. Shortened up the motor mount area so the motor pokes out about 5mm past the end of the rocket. Giving you a little room to grab it with your fingers.

Otherwise it's all the same. I did flip the objects to their proper printing position. I print my nosecones standing up. HAL recommended printing the nosecone on it's side. Up to you!

Thanks HAL 9000
I have yet to print this. But if I have any major issues I'll come back and make edits. Otherwise assume it all went well.