MakerWorld
Electronics
Go to Model
19" Rack cable management with cable detent
61
Downloads
16
Likes
28
Makes
In this remix of the original design cable detent was added to keep them sagging into the organizer openings.Also the assembly features of the two parts were changed to have the same mesh/model for both left and the right side, to reduce mistakes while printing.The thickness of the part where the screw holes are, is reduced to 4mm to account for shorter screws.The two color design was achieved with a pause on the 5th layer and manual filament swap.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!