Thingiverse
Watering pot
by klajo
7
Downloads
6
Likes
0
Makes
This watering pot is designed to be printed using the *vase mode* available in several slicers. The model is solid, but the vase mode turns this into a hollow, working watering pot. Check the *Spiralize outer contour* option under expert settings in Cura.
The pot was printed at 30 mm height and glued to a small servo controlled by an Arduino in order to water plants during a hackathon.
The pot was printed at 30 mm height and glued to a small servo controlled by an Arduino in order to water plants during a hackathon.
Sign in to leave a comment
Sign in