Thingiverse
Watering bucket
by klajo
4
Downloads
1
Likes
0
Makes
This watering bucket is designed to be printed using the *vase mode* available in several slicers. The model is solid, but the vase mode turns this into a hollow, working watering bucket. Check the *Spiralize outer contour* option under expert settings in Cura.
The bucket was printed at 30 mm height and glued to a small servo controlled by an Arduino in order to water plants during a hackathon.
Hint: Use the scaling options in the slicer to change the wider/narrower or higher/lower version
The bucket was printed at 30 mm height and glued to a small servo controlled by an Arduino in order to water plants during a hackathon.
Hint: Use the scaling options in the slicer to change the wider/narrower or higher/lower version
Sign in to leave a comment
Sign in