Thingiverse
1" to 1.125" Threadless stem shim
by aiber
9
Downloads
6
Likes
0
Makes
Shim that adapts the much more common 1.125" (1 1/8") threadless stems to clamp on to 1" steerers.
Cut down to match the height of your stem, or if smaller, make it the largest percentage below 100% possible. It would be much better to just go in the SLDPRT & extrude it further, then remove the excess.
Do not just leave this larger than the height of your stem or else the threadless adjustment doesn't actually work. Use 1" headset spacers (I uploaded these) for the rest of the steerer. If
Cut down to match the height of your stem, or if smaller, make it the largest percentage below 100% possible. It would be much better to just go in the SLDPRT & extrude it further, then remove the excess.
Do not just leave this larger than the height of your stem or else the threadless adjustment doesn't actually work. Use 1" headset spacers (I uploaded these) for the rest of the steerer. If
Sign in to leave a comment
Sign in