Thingiverse
1S XT30 holder Eachine Trashcan / Mobula7
por iFrostizz
2
Descargas
3
Likes
0
Makes
Hey!
Here is a fresh .STL file that could be very useful if you did the "XT-30" Upgrade on your tiny brushless whoop !
One part will hold the XT-30 and the other one will hold the two lipos so you can run it 2S.
You should print it in TPU with 100% infill
The XT-30 hold is a little tight, you can use a very thin screwdriver to put it inside and it'll never move in flight.
Here is a fresh .STL file that could be very useful if you did the "XT-30" Upgrade on your tiny brushless whoop !
One part will hold the XT-30 and the other one will hold the two lipos so you can run it 2S.
You should print it in TPU with 100% infill
The XT-30 hold is a little tight, you can use a very thin screwdriver to put it inside and it'll never move in flight.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
