Thingiverse
1u Stand
von darkstar2002
9
Downloads
2
Likes
1
Makes
Little stand I made so that I can hold a 1u network switch up off the table a little bit.
Print it laying down. I have 3 perimeters and 3 top/bottom layers. I have 50% octet infill. Use supports.
It is very strong I use 4 of these to hold up a big 24port poe switch on our work bench.
Print it laying down. I have 3 perimeters and 3 top/bottom layers. I have 50% octet infill. Use supports.
It is very strong I use 4 of these to hold up a big 24port poe switch on our work bench.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
