Thingiverse
1x2x6
di kequals
46
Download
37
Likes
0
Makes
A 1x2x6 twisty puzzle. Every layer can turn in increments of 180 degrees. This puzzle cannot shapeshift.
To make, print each part by the number indicated on the filename:
* 1 Alignment
* 1 Pin
* 3 Short
* 4 Medium
* 4 Long
The screw I used was M3 x 5mm. I first found a small M3 screw, then manually ground it down until it was 5mm long. Make sure that your screw is still threaded. The screw needs to be extremely small for the puzzle to work.
Stickers are standard 57mm 3x3.
To make, print each part by the number indicated on the filename:
* 1 Alignment
* 1 Pin
* 3 Short
* 4 Medium
* 4 Long
The screw I used was M3 x 5mm. I first found a small M3 screw, then manually ground it down until it was 5mm long. Make sure that your screw is still threaded. The screw needs to be extremely small for the puzzle to work.
Stickers are standard 57mm 3x3.
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!