Thingiverse
1x4x4
por kequals
87
Descargas
60
Likes
1
Makes
A non-pillowed 1x4x4 (floppy revenge) twisty puzzle. This puzzle can make 180 degree turns.
To make, print each part by the number indicated on the filename.
* 4 Corner
* 8 Edge
* 3 Center 1
* 1 Center 2
* 1 Pin
The screw I used was M3 x 4mm. I first found a small M3 screw, then manually ground it down until it was 4mm long. Make sure that your screw is still threaded. The screw needs to be extremely small for the puzzle to work, while still having enough threads to not fall out. The screw was the hardest part of making the puzzle work.
The top/bottom and side stickers can be cut from the template. The corner pieces of the top and bottom are regular 57mm 3x3 stickers.
To make, print each part by the number indicated on the filename.
* 4 Corner
* 8 Edge
* 3 Center 1
* 1 Center 2
* 1 Pin
The screw I used was M3 x 4mm. I first found a small M3 screw, then manually ground it down until it was 4mm long. Make sure that your screw is still threaded. The screw needs to be extremely small for the puzzle to work, while still having enough threads to not fall out. The screw was the hardest part of making the puzzle work.
The top/bottom and side stickers can be cut from the template. The corner pieces of the top and bottom are regular 57mm 3x3 stickers.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!