Thingiverse
1x4x5
by kequals
40
Downloads
32
Likes
0
Makes
A non-pillowed 1x4x5 twisty puzzle.
To make the puzzle, print each piece by the number indicated on the filename:
* 4 Corner
* 4 Wing Edge Side 4
* 4 Wing Edge Side 5
* 1 Left Edge
* 1 Right Edge
* 2 Edge Center
* 4 Left Corner Center
* 4 Right Corner Center
* 1 Edge Cap
You need 1 M3x35mm screws and optionally 1 spring. You need a long screw (a Pyraminx one will do) and you can buy it here:
https://www.thecubicle.com/collections/accessories/products/moyu-pyraminx-hardware-set
Stickers can be cut from the attached template.
To make the puzzle, print each piece by the number indicated on the filename:
* 4 Corner
* 4 Wing Edge Side 4
* 4 Wing Edge Side 5
* 1 Left Edge
* 1 Right Edge
* 2 Edge Center
* 4 Left Corner Center
* 4 Right Corner Center
* 1 Edge Cap
You need 1 M3x35mm screws and optionally 1 spring. You need a long screw (a Pyraminx one will do) and you can buy it here:
https://www.thecubicle.com/collections/accessories/products/moyu-pyraminx-hardware-set
Stickers can be cut from the attached template.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!